Model G0846 (Mfd. Since 02/18)
-17-
2. Attach hold-down post to table with 12mm flat
washer, 12mm lock washer, and M12-1.75
hex nut (see
Figure 9).
3. Slide hold-down clamp assembly over hold-
down post using either mounting hole for now
(see
Figure 10). Tighten lock handle.
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to
Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
Figure 9. Mounting hold-down post to table.
4. Place collar inside end of indexing guide with
flat side facing out, then secure to stud with
8mm fender washer, standoff hex nut, lock
handle, compression spring, and shoulder
screw (see
Figure 11).
Figure 10. Placement of hold-down clamp
assembly.
Hold-Down
Post
Mounting
Holes
Lock
Handle
To assemble machine:
1. Loosely attach (1) lock handle to hold-down
clamp assembly (see
Figure 8).
Figure 11. Installing components on indexing
guide shaft.
Collar
Indexing
Guide
Standoff
Hex Nut
Lock
Handle
Figure 8. Lock handle attached to hold-down
clamp assembly.
Hold-Down
Clamp Assembly
Lock
Handle
Summary of Contents for G0846
Page 52: ......