-18-
Model G0828/G0829 (Mfd. Since 02/17)
Using Angle Cutting
Guide
Use the angle cutting guide as a side work stop to
cut a workpiece at an angle other than 90°.
To use angle cutting guide:
1. Calculate angle of cut and mark on workpiece.
2. Loosen adjustable lever on angle cutting
guide, use scale to set angle to match desired
cut, then tighten lever (see
Figure 17).
3. Align workpiece with angle cutting guide and
position cut mark beneath blade to verify cut
angle.
4. Pull cutting lever to cut workpiece.
Adjusting 90° Guide
The 90° guide (see
Figure 16) helps the operator
square the workpiece with the blades. To work
properly, it must be square with the blades.
Tools Needed
Qty
Square ............................................................... 1
Hex Wrench 5mm .............................................. 1
To square 90° guide with upper blade:
1. Loosen (2) cap screws securing 90° guide.
2. Use cutting lever to fully lower blade.
3. Place square against hold-down bar and 90°
guide.
4. Keeping square even against hold-down bar,
adjust 90° guide so it is even against square,
then re-tighten cap screws on 90° guide to
secure setting.
5. Lift cutting lever to return blade to up position.
Figure 16. 90° guide (blade cover removed for
clarity).
Hold-Down Bar
90° Guide
Figure 17. G0828/G0829 angle cutting guide
(blade cover removed for clarity).
Angle
Indicator
Adjustable
Lever
Angle
Cutting
Guide
Scale
Summary of Contents for G0828
Page 36: ......
