Model G0773 (Mfd. Since 4/17)
-55-
Removing Tooling
Tools Needed
Qty
Wrench 17mm.................................................... 1
Spindle Locking Pin ........................................... 1
Brass Hammer .................................................. 1
To remove tooling:
1. DISCONNECT MACHINE FROM POWER!
2. Remove drawbar cap.
3. Insert spindle locking pin into spindle, and
loosen drawbar (see
Figure 91 on Page 54).
4. Unthread drawbar from tooling one full rota-
tion.
Note: Do not fully unthread tooling from
drawbar or the drawbar and tool threads
could be damaged in the next step.
Figure 92. Example of tapping drawbar to
unseat tool taper.
6. Hold onto tooling with one hand and fully
unthread drawbar with the other hand.
5. Tap top of drawbar with hammer to unseat
taper (see
Figure 92).
