-18-
Model G0773 (Mfd. Since 4/17)
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Installed Components (Figure 7)
Qty.
A. Lathe Chuck Guard .................................... 1
B. 3-Jaw Chuck .............................................. 1
C. 4-Way Tool Post ......................................... 1
D. Milling Headstock ....................................... 1
E. Mill Safety Shield ........................................ 1
F. Backsplash ................................................. 1
G. Tailstock ...................................................... 1
H. Drill Chuck
1
⁄
2
" ............................................ 1
Loose Components (Figure 8)
Qty.
I. Open-End Wrench Set
(8/10, 12/14, 17/19, 36mm) ................... 1 Ea.
J. Dead Center MT#5 ..................................... 1
K. Dead Center MT#3 ..................................... 1
L. Lathe Chuck Key ........................................ 1
M. Square Socket T-Wrench ........................... 1
N. Spanner Wrench 63mm Pin-Type .............. 1
O. Spanner Wrench 45–52mm Hook-Type ..... 1
P. Hardware Bag ............................................ 1
—Cap Screw M10-1.5 x 35 ........................ 4
—Cap Screw M10-1.5 x 30 ........................ 3
—Cap Screw M8-1.25 x 25 ........................ 4
—Flat Washer 10mm ................................. 7
—Lock Washer 10mm ................................ 3
Q. Spindle Locking Pin .................................... 1
R. Handwheel Handle (Cross Slide) ............... 1
S. Handwheel Handle (Carriage) .................... 1
T. Timing Belt ................................................. 1
U. V-Belt .......................................................... 1
V. Mill Chuck Key
5
⁄
16
" AH 11T SD-
5
⁄
8
" ............ 1
W. Hex Wrench Set (3, 4, 5, 6, 8mm) ........1 Ea.
X. Change Gear Set (35, 50, 60T) ............1 Ea.
Y. 3-Jaw Chuck External Jaw Set .................. 1
Figure 7. Components installed when shipped.
A
B
C
F
G
H
D
E
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Figure 8. Components loose when shipped.
S
U
L
M
N
O
P
Q
R
S
T
U
Y
V
W
X
I
K
J
