Model G0772 (Mfd. Since 05/15)
-53-
Setting Up Crosscut
Fence
Before using the crosscut fence to perform cutting
operations, it must be set up properly in order to
make accurate cuts. This includes positioning the
crosscut fence on the crosscut table, adjusting the
support bar, adjusting the distance of the crosscut
fence from the blade, and positioning the crosscut
table along the sliding table.
The crosscut fence can be mounted in the front
or rear position (see
Figure 98) depending on
the size of the workpiece and which position will
provide the safest operation. The support bar
is adjusted accordingly for maximum workpiece
support.
Front
Position
Crosscut
Table
Support
Bar
Rear
Position
Crosscut
Table
Support
Bar
Figure 98. Crosscut fence front and rear table
mounting positions.
Positioning Crosscut Fence
2. Loosen and disengage lock handles shown in
Figure 99.
Figure 99. Location of lock handles that secure
crosscut fence to crosscut table.
Lock Handles
3. Lift fence up and place left guide pin in 90°
slot, then place right guide pin in mounting
hole in crosscut table (see
Figure 100).
Figure 101. Location of lock knob that secures
support bar to crosscut table.
Support Bar
Lock Knob
4. Engage and tighten lock handles.
5. Loosen support bar lock knob shown in
Figure 101, slide support bar into position
required for operation, then tighten lock knob.
Figure 100. Crosscut fence pins and mounting
locations.
Mounting Hole
Left Guide Pin
Right Guide Pin
90° Slot
Crosscut Fence In
Rear Position
To position crosscut fence:
1. DISCONNECT MACHINE FROM POWER!