-32-
Model G0772 (Mfd. Since 05/15)
35. Install both flip stops on crosscut fence by
unlocking extension piece lock knob, sliding
extension piece out, sliding clamp bar on bot-
tom of flip stops into fence (see
Figure 43),
then tightening lock knob.
38. Install push handle on sliding table by loos-
ening lock knob on push handle, installing
handle onto right end of sliding table rail, then
tightening knob (see
Figure 46).
Figure 46. Push handle installed on sliding table
rail.
Lock Knob
Rail
39. Install tool holder on right side of saw cabinet,
as shown in
Figure 47, with included M6-1 x
12 button head cap screws.
40. Connect saw to power (refer to Power
Connection on Page 37).
41. Perform Test Run procedure (refer to Page
38).
42. Set blade to 0° using control panel (see
Figure 3 on Page 5), and then raise blade all
the way up.
43. DISCONNECT MACHINE FROM POWER!
Figure 47. Tool holder installed on saw cabinet.
x 2
Figure 43. Flip stops installed on crosscut fence.
Inside Flip
Stop
Clamp Bar
36. Install wood end-cap onto crosscut fence with
(4) #6 x 1" tap screws and (4) 4mm flat wash-
ers, as shown in
Figure 44.
Figure 44. Wood end-cap installed on crosscut
fence.
x 4
37. Place miter fence bracket (see Figure 45)
onto sliding table rail. Slide miter fence along
sliding table rail and thread pivot knob into
block (see
Figure 45).
Figure 45. Miter fence installed on sliding table.
Rail
Miter Fence
Bracket
Pivot Knob
Block
Pivot Knob
Lock Knob
Outside Flip Stop