-30-
Model G0772 (Mfd. Since 05/15)
24. Attach upper support arm to lower support
arm with (2) M10-1.5 x 25 hex bolts, (2)
10mm lock washers, and (2) 10mm flat wash-
ers, as shown in
Figure 34.
25. Remove (4) pre-installed M8-1.25 x 20 cap
screws and (4) 8mm lock washers from end
of upper support arm (see
Figure 34).
Figure 34. Upper support arm connected to
lower support arm.
27. Push slide lock on blade guard housing to
OPEN, then slide on flat blade guard, as
shown in
Figure 36.
29. Adjust cap screws, lock nuts, and hex bolts
on swing arm (see
Figure 37) to position
blade guard parallel with blade slot, then
tighten all fasteners.
Figure 37. Location of components for adjusting
blade guard to blade slot.
28. Adjust cap screws installed in Step 26 to
make bottom of blade guard parallel with cast
iron table, tighten cap screws, then secure
lock knob shown in
Figure 37.
Upper
Support
Arm
x 2
Lower
Support
Arm
Lock Knob
26. Secure swing arm to upper support arm with
four cap screws and lock washers removed in
previous step, as shown in
Figure 35.
Figure 35. Swing arm mounted to upper support
arm.
Upper Support Arm
x 4
Swing Arm
Figure 36. Installing flat blade guard onto guard
housing.
Slide Lock
Flat Blade
Guard
Blade
Guard
Housing