Model G0771Z (Mfd. Since 01/21)
-25-
Figure 34.
Example of removing switch key from
paddle switch.
For your convenience, the adjustments listed
below have been performed at the factory and no
further setup is required to operate this machine.
However, because of the many variables involved
with shipping, we recommend that you verify the
following adjustments to ensure that this saw cuts
safely and accurately.
Step-by-step instructions for these adjustments
can be found in
SECTION 8: SERVICE.
Adjustments that should be verified:
1. Blade Tilt Calibration (Page 60).
2. Miter Slot to Blade Parallelism (Page 62).
3. Table/Dado Insert Adjustment (Page 70).
Recommended
Adjustments
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
The test run consists of verifying the following:
1) The motor powers up and runs correctly, and
2) the safety disabling mechanism on the switch
works correctly.
To test run machine:
1.
Make sure you have read safety instructions
at beginning of manual and that machine is
set up properly.
2.
Lower blade all the way down, and make sure
all tools and objects used during setup are
cleared away from machine.
3.
Connect machine to power source.
4.
Turn machine ON, verify motor operation,
then turn machine OFF.
The motor should run smoothly and without
unusual problems or noises.
5.
Remove switch disabling key, as shown in
Figure 34
.
6.
Try to start machine with paddle switch.
— If machine does not start, switch disabling
feature is working as designed.
— If machine starts, immediately stop
machine. The switch disabling feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
