Grizzly G0630, Owner'S Manual

Page: 11 / 28

G0630 Extra Long Downdraft Table
-9-
Figure 2.
Typical type 5-15 plug and receptacle.
Serious personal injury could occur if you
connect the downdraft table to the power
source before you have completed the setup
process. DO NOT connect this machine to
the power source until instructed to do so.
110V Operation
Amperage Draw
The Model G0630 draws the following amps
under maximum load:
Amp Draw ...................................................... 14A
Circuit Recommendations
We recommend using a dedicated circuit for this
machine. You MUST connect your machine to a
grounded circuit that is rated for the amperage
given below. Never replace a circuit breaker on
an existing circuit with one of higher amperage
without consulting a qualified electrician to ensure
compliance with wiring codes.
If you are unsure
about the wiring codes in your area or you
plan to connect your machine to a shared cir-
cuit, consult a qualified electrician.
110V Circuit ...........................................20 Amps
Plug/Receptacle Type
Included Plug Type ........................... NEMA 5-15
This machine must have a ground prong in
the plug to help ensure that it is grounded.
DO NOT remove ground prong from plug
to fit into a two-pronged outlet! If the plug
will not fit the outlet, have the proper outlet
installed by a qualified electrician.
Extension Cords
We do not recommend the use of extension cords,
but if you find it absolutely necessary:
• Use a least a 14 gauge cord that does not
exceed 50 feet in length!
• The extension cord must also contain a
ground wire and plug pin.
• A qualified electrician MUST size cords over
50 feet long to prevent motor damage.
SECTION 2: CIRCUIT REQUIREMENTS
Electrocution or fire could
result if this machine is
not grounded correctly or
if your electrical configu-
ration does not comply
with local and state codes.
Ensure compliance by
checking with a qualified
electrician!