-32-
Model G0611X (Mfd. 07/15)
SECTION 6: MAINTENANCE
Cleaning
Schedule
Most of the bearings in the machine are sealed
and lubricated for life.
The spindle has one grease fitting that must be
greased approximately every 40 hours or one
week of regular use (refer to
Figure 56). Use high
temperature bearing grease.
Lubrication
Figure 56. Spindle grease fitting located on
headstock control panel.
To grease the spindle, connect the fitting to a
grease gun and give the spindle one pump of
grease.
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check (8 Hours)
•
Check/tighten cutter set screws.
•
Clean debirs/sawdust from clamps to ensure
that they do not interfere with the clamping
ability.
•
Clean/vacuum dust buildup from inside cabi-
net and off motor.
•
Unpainted cast-iron portions of the table and
the headstock travel rods should be cleaned
and wiped down with a metal protectant.
•
Check/replace damaged power cords or
wires.
•
Check/add air tool oil to the air supply unit
lubricator.
•
Check/drain the air supply unit water filter.
(Drain by sliding the white shaft to the other
side.)
Weekly Maintenance (40 Hours)
•
Grease the spindle.
Monthly Check (320 Hours)
•
Belt tension, damage, or wear.
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
Cleaning the Model G0611X is relatively easy.
Vacuum excess wood chips and sawdust, and
wipe off the remaining dust with a dry cloth. If any
resin has built up, use a resin dissolving cleaner
to remove it.
Protect the unpainted cast iron table by wiping
it clean after every use—this ensures moisture
from wood dust does not remain on bare metal
surfaces. Keep the table rust-free with regular
applications of products like G96
®
Gun Treatment,
SLIPIT
®
, or Boeshield
®
T-9 (see
Page 29 for more
details).
Summary of Contents for G0611X
Page 52: ......
