-20-
Model G0477
15" Planer/Moulder
3. place the workpiece below the depth-of-cut
gauge, as shown in
figure 15.
4. Lower the headstock until it reaches the pre-
set thickness. the headstock will not be able
to move lower than the preset height.
5. if the depth-of-cut gauge reads greater than
3
⁄
32
", repeat
Steps 1–4 with a larger thickness
selected. We recommend making multiple,
shallow passes for cuts deeper than
3
⁄
32
" (
1
⁄
16
"
for workpieces 8"–15" wide).
6. remove the workpiece from the planer/
moulder.
7. start the planer/moulder.
8. place the flat side of the board down on the
table, and feed the workpiece through the
planer/moulder, making sure not to stand
directly in front or behind the workpiece.
figure 15. depth-of-cut gauge.
Roller height
Adjustment
the Model g0477 features three infeed/outfeed
roller height settings. the provided special wrench
is used to turn the roller height adjuster, as shown
in
figure 16.
figure 16. roller height adjuster.
to adjust the infeed/outfeed roller height:
1. unpLug thE pLAnEr/MouLdEr FroM
thE poWEr sourCE!
2. raise the headstock clear of the planer/
moulder table.
3. use the special wrench provided to turn the
roller height adjuster to one of the three pre-
set settings shown in
figure 17.
roller height
Adjuster
SETTING 1
Planing
SETTING 2
Moulding
SETTING 3
1st moulding pass
INFEED/OUTFEED ROLLER HEIGHT ADJUSTMENT
figure 17. roller height adjuster settings.
