Grizzly ERM 1846 GTA, Translation Of The Original Instructions For Use

Page: 29 / 128

GB
29
or plastic to remove adherent plant
remains from the wheels, ventilation
holes, ejection hole and blade area.
Do not use hard or pointed objects, as
these may damage the blade.
• Oil the wheels from time to time.
• Before each use, check the lawnmower
for obvious defects such as loose, worn
or damaged parts. Check that all nuts,
bolts and screws are sitting firmly.
• Check the covers and protective de-
vices for damage and check that they
are sitting correctly. Replace them if
necessary.
Changing the Blade
Switch off the equipment before all
maintenance and cleaning work,
disconnect the plug and wait until
the blade stops.
If the blade is blunt, it can be sharpened
by a specialist workshop. If the blade
is damaged or showing signs of imbal-
ance, it must be replaced (see chapter on
“Spare Parts”).
1. Turn the equipment over.
2. Use sturdy gloves and hold
the blade firmly (27). Turn the
blade screw (28) anticlockwise
off of the motor spindle using a
screwdriver.
3. Install the new blade in the
reverse order. Ensure that the
blade is positioned correctly and
the screw tightened firmly.
Adjusting the Bowden Cable
If the Bowden cable ( 18) becomes
misplaced for the drive and has too much
play, it can be adjusted.
1. Loosen the small lock nut (18a).
2. - Turn the adjusting nut (18b)
anticlockwise:
The Bowden cable shortens.
- Turn the adjusting nut (18b)
clockwise:
The Bowden cable lengthens.
Storage
In order for the device takes up
less space, loosen the two star
knob nuts (3) at the bow-type
handle (1) and remove the two
star knob nuts and screws (
6) on the lower bar (4). Now the
bow-type handle (1) and the lower
bar (4) can be collapsed together.
Make sure that the cable is not
clamped.
• Keep the equipment dry and out of
reach of children.
• Allow the motor to cool before storing
the equipment in a confined space.
• Do not cover the equipment with nylon
bags as moisture could build up.
We will not be liable for damages caused
by our equipment where these are caused
by improper repair or the use of non-
original parts or by use other than for the
intended purpose.