Page 6
Test Run
Once the assembly is complete, test run your machine to make sure it runs properly and
is ready for regular operation.
The test run consists of verifying the following: 1) The motor powers up and runs
correctly, and 2) the safety disabling mechanism works correctly.
If, during the test run, you cannot easily locate the source of an unusual noise or
vibration, stop using the machine immediately, then review
Troubleshooting
on
Page
61
.
If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for
assistance.
To test run the machine:
1.Make sure that you have successfully com- pleted the Initial Blade Tracking
procedure on Page 28 before continuing.
2.Make sure you have read the safety instruc- tions at the beginning of the manual
and that the machine is setup properly.
3.Make sure all tools and objects used during setup are cleared away from the
machine.
4.Connect the machine to the power source.
5.Test the operation of the machine to verify
that it starts and operates correctly.
G0513, G0513P, G0513ANV, & G0513X2 Only
a.
Verify that the machine is operating correctly by pressing the power button.
—
When operating correctly, the machine runs smoothly with little or no vibration
or rubbing noises.
—
Investigate and correct strange or unusual noises or vibrations before operating
the machine further. Always disconnect the machine from power when investigating
or correcting potential problems.
