Page 12
G0513 Series Bandsaws
-37-
Adjusting Blade Guides (G0513,
G0513P, & G0513ANV)
Tools Needed
Qty
Hex Wrench 5mm .............................................. 1
Feeler Gauge 0.004" ................................1 Each
Crisp Dollar Bill (Optional) ................................. 1
Fine Ruler .......................................................... 1
Tip:
You can use a crisp dollar bill in place of the
feeler gauge. The thickness of the bill is approxi-
mately 0.004" .
To adjust the upper blade guides:
1.
DISCONNECT BANDSAW FROM POWER!
2.
Loosen the thumb screws shown in
Figure 48
.
7aVYZ
<j^YZ
Iddi]
<jaaZi
7aVYZ
%#%&+
<Ve
Hjeedgi
7ZVg^c\
7aVYZ
%#%&+
<Ve
%#%&+
<Ve
Hjeedgi
7ZVg^c\
7aVYZ
<j^YZh
%#%%)
<Ve
7aVYZ
Figure 49.
Correct gap between guide guides
and blade.
3.
By hand, adjust the distance of the guides
approximately 0.004" from the sides of the
blades (see
Figure 49
), then re-tighten the
thumb screws to secure the setting.
Figure 48.
Upper blade guides side-to-side con-
trols.
Blade
Guides
Thumb
Screws
Figure 50.
Back of upper blade guides.
Guide Block
Cap Screw
Guide
Block
4.
Loosen the guide block cap screw shown in
Figure 50
.
