The unit can operate without DMX signal (in AUTOMATIC mode) and can be set so that a single MASTER unit will
command a series of SLAVE units. This function is particularly useful when more units are desired to execute the
same programme in synchrony.
The following picture shows an example of a Master-Slave layout.
8.1 MASTER configuration
To execute the preset colour-changer programme set the dip-switch Master to ON.
If the unit is properly set up as Master, the red led next to the dip-switch panel will flash.
The following pictures show some examples of MASTER units configuration.
8.2 SLAVE configuration
To set up the unit as SLAVE set the unit with dmx address 001.
If the unit is properly set up as SLAVE and the signal is present, the red led next to the dip-switch panel will
constantly remain on.
IN
OUT
IN
OUT
IN
OUT
Terminal resistor
(R=120
Ω
not included!)
MASTER
SLAVE 1
SLAVE N
SLAVE 2
8.0 Master-Slave and Automatic mode
Unit set as Master (Master = ON)
Warning!
If MASTER-SLAVE mode is being used, no other DMX control device must be present along the line!!
English
25
