1.0 PACKING
Check the content of the box carefully and in case of damage contact your forwarder immediately.
The following items are included in the box:
n° 1 RISALTO unit;
n° 1 instructions leaflet;
2.0 SAFETY
Disconnect the lantern from mains supply before replacing the lamp or servicing the unit.
- This projector has been designed for outdoor and indoor use. For safety operation, maximum
ambient temperature must not exceed 35°C;
- Caution: the temperature of the housing of the projector can reach 90°C;
- Caution: hot lamp; make sure the lamp is cold before attempting to remove it (wait for about 20
minutes);
- Caution: it is strongly recommended that a safety-chain or wire is attached to this projector and
secured to the main mounting framework to arrest the fall of the unit in the unlikely event that the
primary mounting arrangement should fail.
3.0 INSTALLATION
3.1 Fitting the lamp
1) Open the rear lid by removing the 4 screws as per picture 1;
2) Clean the lamp with a cleaning towel and fit it carefully in the lamp holder;
- avoid touching the lamp with fingers or dirty towels;
- do not shake the lamp or hit any hard object inside the unit;
3) Fix the lamp to the lamp holder;
4) Put the rear lid back and fix it in its original position.
11
Pict. 1
Pict. 2
