6
Workbench & Sawhorse Mode
Begin by setting up the legs by following the same steps detailed within Scaffold
Mode section. Then, push the snap buttons on the side of each leg to release them,
then pull the inner legs out to the workbench height. When legs are fully extended
they will snap into place.
NOTE: DO NOT step on the workbench while the legs are fully extended.
Quick Clamp Installation (Clamps not supplied with workbench)
Remove the small plastic part of your quick clamp (Figure 1) then insert the steel
bar into our connector (Figure 2) and put a pin into the lock hole, make sure they
are connected firmly (Figure 3). Put the connector into the sawhorse hole on the
workbench surface and rotate at least 30 degrees (Figure 4). With the help of the 2
vice pegs on the workbench, Sawhorse Mode is completed.
POWER & CONNECTIVITY
Your
7-in-1 Multi-Purpose Workbench
is equipped with 2 grounded 120V electrical
outlets to power your projects. Plug in saws, sanders, our random orbitals whatever
tool you need. The plug array also has 2 USB ports to charge your mobile devices and
features a 15-amp surge protector for added peace of mind.
(Clamps not included with workbench.)
3.
4.
Press snap button
Legs release
& extend
1.
2.
