Grindmaster Crathco 5512, Operation And Instruction Manual

Page: 5 / 44

Crathco
®
5512 Manual Page 5
Installation of Exposed Filter Accessory Kit (optional)
(Part #W089.0206)
1. Remove the four panel screws.
2. Pull the bottom of the panel out.
3. Run a bead of the silicone adhesive at the inside back of the bottom
filter channel. (2)
4. Install the channel over the end of the side panel so the adhesive in
the channel contacts the bottom edge of the side panel.
5. Put the panel with the channel added, back in place on the machine and reinstall the two lower panel screws.
6. Apply silicone adhesive to the length of the top edge of the upper filter channel (1) before installing, then wipe off
any excess.
7. Install the upper channel using the upper panel screws.
8. Slide filter (3) in from the front with the arrows pointing toward the existing panel. The thick wire side of the filter
should face outward.
Installation of Spinner/Mixer Accessory Kit (optional)
(W047119 5512 Spinner Mount Bracket)
1. Turn to "OFF" and unplug the freezer from the electrical power
source.
2. Remove the existing panel screws (F).
3. Install (B) to the front panel of (A) using the cap screws (E).
4. Re-install existing panel screws (F) through the
obround holes in the spinner mount bracket (B).
5. Install the spinner (C) using mounting screws (D).
6. Connect white and brown wire from the spinner (C) to the
red wire from the electrical box using the blue wire nut
provided.
7. Connect white and blue wire from the spinner (C) to the blue wire
from the electrical box using the blue wire nut provided.
8. Connect green and yellow wire from the spinner (C) to the green wire from the electrical box using the blue wire
nut provided.(See Figure G)
9. See the spinner-wiring diagrams on page 37 to locate spinner wire connections.
Figure F
Electrical box
Spinner Mounting Bracket
Spinner
Mounting Screws
Mounting Screws
Panel Screws
Figure G