12
13
PROGRAMMING THE QUANTITY
OF BEVERAGE IN A CUP
Note:
The quantity of coffee dispensed may be programmed,
from a minimum of 30mL to a maximum of 250mL.
Note:
Recommended Programming/Factory Programming:
- 30mL: Single Espresso Shot
- 60mL: Double Espresso Shot
- 120mL: Hot Water button
Note:
Quantities are approximate and may vary slightly between capsules.
Raise the
Lever
to
open the
Capsule
Compartment
.
Press and HOLD
the desired
beverage button.
Machine will beep
once programming
has started.
On reaching the
desired amount
of beverage,
release the button.
Machine will
beep 3 times, the
machine is now
programmed.
Close the
Lever
and place a cup
or mug under the
Coffee Dispensing
Spout
.
Raise the
Lever
to
eject the capsule
into the
Used
Capsule Drawer
.
Close the
Lever
.
Note:
The
Cappuccino,
Latte
and
Milk Only
buttons
are unable to be
programmed and will
dispense a fixed
quantity of milk.
Insert the capsule,
pressing it gently
into place.
1.
5.
2.
6.
3.
7.
4.
i.
Note:
If
Indicator Light
continues to blink repeat
Step 3
.
When the
Descaling Indicator Light
blinks
ORANGE
(after which it
will remain lit) and the machine beeps, it is advisable to perform
the
Descaling Cycle
.
See section: Descaling on
Page 17
.
The
Water Tank
is
empty when the
Indicator Ligh
t
blinks
RED
and the
appliance beeps
continuously.
Fill the
Water
Tank
with fresh,
still water (not
carbonated).
When the button
lights turn on and
remain steadily lit,
the appliance is
ready for use.
Press the
Single
or
Double
Espresso
button
. Wait for
the machine to
complete the
priming cycle as it
fills with water.
When all the button lights continuously blink, the machine is
warming up (this will take about 1 min.).
GENERAL OPERATING INDICATIONS
DECALING SIGNAL:
HEATING:
WHEN THE WATER RUNS OUT DURING OPERATION:
2.
Continued on next page
3.
1.
4.
