SINEWAVE GRINFINEON CONTROLLER MANUAL
Rev 2.1
-4-
2
Installation and Hookup
The motor controller end plates have a flange with holes to facilitate securing to
the vehicle. We recommend locating it in place where the ON/OFF switch is
accessible and where it still has good exposure to air flow. Common bicycle
locations include on the front of the rear rack support, between the seat tube and
the rear wheel, or on the top tube with front motors.
Figure 2: Common mounting locations and orientations
Although it is tempting, we do not recommend putting the controller inside a bag
or enclosure box that blocks exposure to air flow, as it will be more susceptible to
overheating. The silicone grommets on the controller end plates do an excellent
job of keeping water out, so there is little concern about having the controller
exposed to the elements, and the orientation of the installed controller does not
matter.
2.1
Basic Hookup
The controller has 6 cables coming out of it: Battery, Motor Phase, Motor Hall,
Throttle, Ebrake, and Cycle Analyst. At the bare minimum, the controller just
needs a throttle, battery pack, and motor connection in order to work:
