20
4. Turn the control knob(s) to the “IGNITE / HI” setting, and preheat the grill for 15 minutes. The grill lid
should be closed during the pre-heat period.
5. Place the food on the grill and cook to the desired degree of preparation. If necessary, adjust the heat
setting. The control knob may be positioned at any setting between “HI” and “LO”.
L
L
L
LIGHTING
IGHTING
IGHTING
IGHTING INSTRUCTIONS
INSTRUCTIONS
INSTRUCTIONS
INSTRUCTIONS
Before
Before
Before
Before Lighting
Lighting
Lighting
Lighting
Inspect the gas supply hose prior to turning on the gas. If there is evidence of cuts, wear, or abrasion, it
must be replaced prior to use.
Screw the regulator (type QCC1) onto the cylinder, and leak check the hose and regulator connections
before operating the grill (see the “Leak Testing” instructions on page 18).
Only the pressure regulator and hose assembly supplied with the unit should be used. Never substitute
regulators. If a replacement is necessary, contact customer service for proper replacement.
WARNING
WARNING
WARNING
WARNING
Do not use the grill if the odor of gas is present. Contact customer service at 1-800-913-8999 in USA and
1-800-648-5864 in Canada.
T
T
T
TO
O
O
O LIGHT
LIGHT
LIGHT
LIGHT THE
THE
THE
THE MAIN
MAIN
MAIN
MAIN BURNERS
BURNERS
BURNERS
BURNERS
1. Open lid during lighting.
2. Make sure all the knobs are in the “OFF” position, and then turn the Liquid Propane Cylinder valve
“ON” by slowly turning counterclockwise.
3. Push and turn Main Burner control knob to IGNITE/HI, at the same time, press and hold electronic
ignition button to light the burner.
4. Once the burner is lit, release the electronic ignition button and knob.
5. If ignition does not occur in 5 seconds, turn the knob to OFF, wait 5 minutes and repeat the lighting
procedure or light by match.
TO
TO
TO
TO LIGHT
LIGHT
LIGHT
LIGHT THE
THE
THE
THE S
S
S
SIDE
IDE
IDE
IDE BURNER
BURNER
BURNER
BURNER
1. Push and turn Side Burner control knob to IGNITE/HI, at the same time, press and hold electronic
ignition button to light the burner.
2. Once the burner is lit, release the electronic ignition button and knob.
3. If ignition does not occur in 5 seconds, turn the knob to OFF, wait 5 minutes and repeat the lighting
procedure or light by match.
Fig.
Fig.
Fig.
Fig. 23
23
23
23
O FF
O FF
O FF
O FF
4
E L E C T R O N IC
IG N IT IO N B U T T O N
2
3
1
O F F
S id e
B u r n e r s
M a in
B u r n e r s
IG NITE
/ H IG H
L O W
IG N ITE
/ HIG H
L O W
IG NITE
/ H IG H
L O W
IG NITE
/ H IG H
L O W
IG N IT E
/ H IG H
L O W
