12
9.
6.
8.
Attach the Door Bracket to the low holes in the
front legs with the end tabs pointing upward and
flange to the rear, pointing downward. Use 2 of
1/4" x 1/2" Phillips Head Screws. Do not fully
tighten. See
Figure 4
.
Attach the Door Stop to the bottom shelf, with
t h e f l an g e f ac i n g t h e f r o n t , u s i n g 2 o f
3/16" x 3/8" Phillips Head Screws. Fully tighten.
See
Figure 4
.
Place doors into the hinge holes of the bottom shelf
and Door Bracket. Push Door Bracket down until
doors are secure and can open and close freely.
Do not full tighten Door Bracket screws. See
Figure 4
.
Remove protective film from Doors. Install Door
Handle to Doors using 4 of 3/16" x 1/4" Phillips Head
Screws. See
Figure 4
.
10.
1/4" x 1/2" Phillips Head Screw x 2
3/16" x 3/8" Phillips Head Screw x 2
Figure 4
Figure 5
DOOR
HANDLE
DOOR BRACKET
DOOR PLATE
3/16" x 1/4"
Phillips Head Screw x 4
DOOR STOP
LIGHTING
STICK
BOWL SIDE PANEL
BOWL BRACKET
BOWL SIDE PANEL
BOWL BRACKET
Tank Holder
Phillips Head Screw
1/4'' x 1/2"
Qty. 4
Part # S
Flange Nut 1/4"
Qty. 4
Part # S
Align the 4 holes (2 on either side) of the Tank
Holder Bracket with the holes on the Cart Bottom
Shelf and insert 4 Phillips Head Screws
1/4'
’
x 1/2'
’
as shown.
From the underside of the Cart Bottom Shelf
secure with 4 Flange Nuts 1/4'
’
.
Note: Be sure to remove preassembled W ing
Bolt on the Tank Holder, unclamp the 2 Arm
Rims where they meet before installing the gas
tank into p ositon and then reclamp the 2 Arm
Rims parts together and secure gas tank
using the Wing Bolt.
7.
