Grifco C10A, Installation And User Manual

Page: 14 / 20

14
2.0 ADVANCED PROGRAMMIMG
Action Button Sequence
SET AUTO TIMER TO CLOSE FROM
THE CONTROLLER
Note: This option is using the main
MCB onboard Auto Close.
If an Expansion Board is fitted, this
feature will not be active.

Press and hold the SET button, then whilst holding press the DOWN button 3 times
The green status light will be ON solid

Press the UP button to increase the auto-timer to close setting in 10-second
increments

Press the DOWN button to decrease the auto-timer to close setting in 10-second
increments

Note: the green light will flash according to the number of 10-second increments
have been set, then goes back to solid ON. For example, a 5-minute auto-close will
be set by increasing the increments until the green light flashes 30 times

Press SET to accept setting and exit learn mode

Note: To cancel the Auto-timer-to close function, enter the learn mode and press the
DOWN button until the number of 10-second increments is ZERO.
The green light will flash repeatedly to indicate the function has been reset, then
return to solid ON

Press STOP to exit