Grifco C10A, Installation And User Manual

Page: 10 / 20

10
OPERATION
To operate the door
Press the UP button on the controller to open the door, press and hold DOWN to close.
Optional Door Behaviour
Latch up / Inch down mode (default):
The door will travel upwards with only a single press and release of the UP button. The door will stop at the set limit. This mode
is latch up.
The door will only travel downwards when the DOWN button is held. The door will stop at the closed limit or when the button is
released. This mode is inch down.
Inch up / Inch down mode:
The door will only travel whilst the UP or DOWN buttons are being held. The door will stop at the limits or when the button is
released. To set this mode refer to Setting door behavior information below.
Latch up and down mode:
Note: This mode is only possible in conjunction with an Entrapment Protection Device such as an Infrared (IR) Beam or a Safe-
ty Bump Edge. Failure to do so may result in damage to property or injury to persons.
The door will travel upwards and downwards with only a single press and release of the UP or DOWN button. The door will stop
at the set limit or when the STOP button is pressed. To set this mode refer to Setting door behavior in the opener manual.
Manual operation
The hand chain provided allows manual operation of the door at all times when the motor is not in use. Warning! Use of the
hand chain during powered operation of the door may result in damage to equipment or injury to the user. Ensure power is shut
off before using manual chain.
CAUTION
Any access control intended for these terminals must be user
operated and in line of sight with the door.
WARNING
Additional 24VDC devices must not draw current from the
MCB in excess of 150mA. Excessive load from connected devic-
es will cause malfunction of the 2.0 opener. For addi-
tional loads, use a separately mounted power supply.