Griesbach Diamond H2O LINQ DLS-120-100, Product Manual

Page: 17 / 21

Diamond LINQ Softener Single Tank Product Manual
pg. 16
F. Advanced Settings
The advanced settings section of the app should only be
programmed by a dealer. These settings contain values that will
affect the performance of the water softener and the quality of the
treated water. These settings will vary from system to system.
Most advanced settings will be set by the manufacturer.
Table 5: Advanced Settings Block Information Table
Days Until Regeneration
Displays the days remaining until
regeneration override occurs
Regeneration Day Override
Displays the maximun number of
days between regenerations
Reserve Capacity
The softener uses a meter to
determine when regeneration is
needed. When the system is set
to regenerate at a certain time,
the reserve capacity is used to
treat water until the
regeneration occurs
Resin Grains Capacity
Displays softener’s capacity in
grains of hardness
Brine Pre-Fill
Enable Pre-fill to fill the Brine
Tank prior to the scheduled
regeneration time
Back Wash Cycle
Displays the amount of time(in
minutes) for the back wash cycle
Brine Draw/ Slow Rinse
Displays the amount of time
(minutes) of brine draw/ slow
rinse. The calcium and
magnesium captured by the
softener is removed by the brine
solution and rinsed to drain
Rapid Rinse
Displays the amount of time
(minutes) for a rapid rinse. This
runs a rinse at a high rate in the
same direction as normal water
flow
Brine Refill
Displays the amount of time
(minutes) it takes to refill the
brine tank. Careful when editing
this setting, it can greatly affect
efficiencies and the softeners
ability to make soft water
Figure 23: Advanced Settings