Figure 6
Greystone Energy Systems, Inc. 150 English Drive, Moncton, NB E1E 4G7 Canada Tel: +1-506-853-3057 Tollfree (North America): +1-800-561-5611 Fax: +1-506-853-6014
Email: [email protected] Web: www.greystoneenergy.com
Figure 7
Figure 9
Figure 8
EMT Connector
Mounting (Enclosure D)
The strap-on sensor installs directly onto any pipe where an immersion
sensor with thermowell can’t be installed.
Once a suitable spot is selected, remove a small block of insulation, if
present. It is recommended that thermal compound be used to
improve heat transfer. Spread a liberal about on the pipe.
Open the worm gear clamp by swiveling the worm gear away from the
clamp and pull the clamp apart, as shown in Figure 1.
Place the sensor plate on the selected mounting area and wrap clamp
around the pipe. Re-insert clamp under the worm gear and pull until
snug. Lock in place by swiveling the worm gear towards the clamp.
Tighten worm gear clamp by using a standard screw driver or hex nut
driver as shown in Figure 2.
The enclosure has a hinged cover with latch. Open cover by pulling
slightly on the latch on the right side of the enclosure. At the same time
pulling on the cover, as illustrated in Figure 8.
Feed conduit through the provided hole in bottom of enclosure and
secure with a lock nut as show in Figure 9. It is recommended that
weatherproof conduit or cable gland fittings be used.
Make wiring connections as per the “Wiring” illustrations on Page 2.
Swing door closed until securely latched. For added security, 2 screws
are provided that may be installed in the integrated screw tabs. See
Figure 10.
DIFFER
EN
TIAL
HIGH
LOW
MID
TEMP
PWR
COM
NC
NO
COM
Figure 10
Thermal Compouind
