H36.0.01.6C-13
Operating Manual GMH 3610
page 4 of 12
7.
Caution, acid!
The electrode contains
KOH
. KOH can cause severe chemical burns!
If leaking, avoid contact!
If there was contact:
• to skin: flush contacted area with large amounts of water for several minutes.
• to clothing: remove contaminated clothing.
• to eyes: flush with large amounts of water for several minutes,
obtain medical treatment.
After swallowing:
• give large volumes of water. DO NOT induce vomiting!
• obtain medical treatment.
5
Display and control elements
5.1 Display elements
Display with two sensors connected:
Main display:
possible views:
Oxygen saturation in %
(% O
2
)
Oxygen concentration
(mg/l)
Secondary display
:
Sensor temperature
(°C or °F)
The secondary display can be configured by means
of the configuration system (p.r.t.
'Configuration'
)
The desired view can be selected by pressing the
-key.
Special display elements:
Min/Max/Hold
:
shows if a min., max. or hold value is displayed in
either the main or the secondary display.
ok arrow
:
indicates that oxygen and temperature values have
been stable for a longer period of time
CAL arrow
:
indicates that an automatic oxygen calibration is car-
ried out
Warning triangle:
indicates a low battery, full logger storage, etc.
Display at reboot:
After switching on the instrument performs a segment test of 2 seconds.
Afterwards some configurations are displayed sequentially: air pressure and if activated: offset settings.
(p.r.t Chapter 6 'Configuration')
Tip: The display of these settings can be aborted by pressing a key after the segment test (keys 2 - 6).
°C
2
Logg
AL
mg/l
ok
mmHg
hPa
SAL
hPa
%O
CAL
MAX
MIN HLD
%
°C
2
Logg
AL
mg/l
ok
mmHg
hPa
SAL
hPa
%O
CAL
