GREER COMPANY
GREER COMPANY
GREER COMPANY
GREER COMPANY
Crane Systems
Crane Systems
Crane Systems
Crane Systems
GREER COMPANY 1918 East Glenwood Place, Santa Ana, CA 92705 Tel: 714) 259-9702 Fax: 714) 259-7626 PN W414107-
MicroGuard
414 System Lattice Boom Cranes Horizontal Display Clyde M4190 Barge Mount OPERATOR'S MANUAL 12/20/01
9 of 21
CRANE
SET UP
WORKING
AREA
STOWED
1
2
3
4
5
6
7
UPPER RIGHT DISPLAY
DEDUCT
PUSH BUTTONS -- LAMPS -- ICONS
PUSH BUTTONS -- LAMPS -- ICONS
PUSH BUTTONS -- LAMPS -- ICONS
PUSH BUTTONS -- LAMPS -- ICONS
THE DISPLAY
THE DISPLAY
THE DISPLAY
THE DISPLAY -- UPPER RIGHT
UPPER RIGHT
UPPER RIGHT
UPPER RIGHT
RADIUS/HEIGHT
RADIUS/HEIGHT
RADIUS/HEIGHT
RADIUS/HEIGHT
shows the
current radius and height. Height is
displayed only when the push button
is pressed and held.When the push
button is not pressed, the read out
is always shown as the radius of
the load.
PARTS
PARTS
PARTS
PARTS----OF
OF
OF
OF----LINE
LINE
LINE
LINE
(20)
is used to
view the current parts-of-line and to
select the parts-of-line in use on the
selected winch.
WINCH (
WINCH (
WINCH (
WINCH (3)
3)
3)
3)
identifies the winch
currently selected. This button is
used to alternate between the front
and rear winch. When switching between winches, the parts-of-line previously selected and recorded for
each winch will be displayed whenever a particular winch is selected.
ANGLE/LENGTH
ANGLE/LENGTH
ANGLE/LENGTH
ANGLE/LENGTH
(4)
provides a read out of angle or length. Length is displayed only when the push
button is pressed and held. When the push button is not pressed, the read out is always shown as the
Angle of the main boom.
WORKING AREA
WORKING AREA
WORKING AREA
WORKING AREA (5
55
5)
receives and displays messages. Messages received in this area will conform to
the current duty selection and the swing position of the crane upper for cranes with swing and multiple
working swing areas.
TARE (6)
TARE (6)
TARE (6)
TARE (6)
extracts or "tares out" the weight of hook and slings. When pushed, this button will show the
actual weight of the load being lifted without the weight of the hooks and slings..
TO SET
TO SET
TO SET
TO SET TARE
TARE
TARE
TARE
With the hook and slings lifted, press & hold the TARE button (6) for three seconds. The
display console will then beep and "zero" the actual load display. The TARE lamp will then illuminate to
indicate that a tare has been set.
TO CLEAR TARE
TO CLEAR TARE
TO CLEAR TARE
TO CLEAR TARE
Press the TARE button. The display console will immediately beep, the actual load
display will show the total weight below the boom head, and the TARE lamp will be off.
CRANE SETUP (7)
CRANE SETUP (7)
CRANE SETUP (7)
CRANE SETUP (7)
indicates the area of the display that provides a read out of the selected
configuration. This icon is also a push button used to start the selection of the crane configuration.
TARE
