GREER COMPANY
GREER COMPANY
GREER COMPANY
GREER COMPANY
Crane Systems
Crane Systems
Crane Systems
Crane Systems
GREER COMPANY 1918 East Glenwood Place, Santa Ana, CA 92705 Tel: 714) 259-9702 Fax: 714) 259-7626 PN W414107-
MicroGuard
414 System Lattice Boom Cranes Horizontal Display Clyde M4190 Barge Mount OPERATOR'S MANUAL 12/20/01
12 of 21
CON
CON
CON
CONFIGURATION SELECTION
FIGURATION SELECTION
FIGURATION SELECTION
FIGURATION SELECTION
In the normal operational mode, the system is programmed to remember the configuration last selected.
Each time the system is powered up, it will automatically choose that configuration. Only when the crane is
rigged differently must a new configuration be selected.
CRANE SET UP
CRANE SET UP
CRANE SET UP
CRANE SET UP
The menu for the crane set up consists of two consecutive steps.
1. Select auxiliary tip or no erected attachment.
2. Select boom configuration (lifting from main or aux hoist).
•
AFTER COMPLETING THE SELECTIONS FOR CRANE SET UP, USE THE WINCH
PUSH BUTTON TO SELECT THE LIFTING POINT.
•
ALL OF THE INFORMATION REQUIRED BY THE SYSTEM IS ENTERED
DURING CRANE SET-UP.
•
ENSURE THAT THE PARTS-OF-LINE IN USE FOR EACH WINCH IS SET. IF NOT, THE
SYSTEM WILL NOT OPERATE CORRECTLY.
FOR SPECIFIC EXAMPLES OF CRANE SET-UP, REFER TO PAGE 14.
PARTS
PARTS
PARTS
PARTS----OF
OF
OF
OF----LINE
LINE
LINE
LINE
Press and hold the PARTS-OF-LINE push button to scroll through the available parts-of-line. The new
value is automatically registered when the button is released. The number chosen applies only to the
winch currently selected. A value must be programmed for both winches.
WINCH
WINCH
WINCH
WINCH
The current selection is shown on the display by selecting the letter "M" for MAIN winch and the letter
"A" FOR AUX WINCH. To change the selection, press the winch select push button. Successive pressing
of this button will change the selection from one to the other. After the initial setup, the system records and
retains the parts-of-line and lifting point for each winch.
DUAL USE PUSH BUTTONS
DUAL USE PUSH BUTTONS
DUAL USE PUSH BUTTONS
DUAL USE PUSH BUTTONS
Some push buttons provide two kinds of information. These are the
RADIUS/HEIGHT and
LENGTH/ANGLE
push buttons.
RADIUS/HEIGHT
RADIUS/HEIGHT
RADIUS/HEIGHT
RADIUS/HEIGHT
When the
RADIUS/HEIGHT
RADIUS/HEIGHT
RADIUS/HEIGHT
RADIUS/HEIGHT
push button is NOT PRESSED, the readout on the
display will ALWAYS show the CURRENT RADIUS.
When the SAME PUSH BUTTON is PRESSED AND HELD, the read out on the display will CHANGE TO
show the CURRENT HEIGHT. This information will remain on the display only as long as the operator
continues to press and hold this push button.
LENGTH/ANGLE
LENGTH/ANGLE
LENGTH/ANGLE
LENGTH/ANGLE
When the
LENGTH/ANGLE
LENGTH/ANGLE
LENGTH/ANGLE
LENGTH/ANGLE
push button is NOT PRESSED, the read out on the
display will ALWAYS show the current LENGTH.
When the SAME PUSH BUTTON is PRESSED AND HELD, the read out on the display will CHANGE to
show the ANGLE OF THE MAIN BOOM. This information will remain on the display only as long as the
operator continues to press and hold this push button.
