GreenWorks 5301002CO, Owner'S Manual

Page: 3 / 20

3
fig.3
fig.4
2 ft .
CAUTION
The gutter cleaner attachment uses two turbo nozzles for
even gutter cleaning in two directions. The attachment
may move as pressure is added or lost. Fully understand
how the attachment moves when adding or lessening
pressure before attempting a cleaning project. If you are
not completely comfortable with the movement of the
attachment under changing pressure conditions, do not
use this product. Failure to do so may result in injury or
property damage.
■ Gutter guards should be removed before starting any
project. The attachment will not work though them.
■ Turn on water supply and start the pressure
washer according to the operator manual
instructions.
■ Before attempting to use the attachment on
your project, move away from the project area.
Depress the trigger to release a stream of water to
get a feel for how the unit will perform during use.
■ The spray wand may kick when the trigger is
released and/or pressure is lost. Before releasing
the trigger, move the nozzle 10 feet way from the
surface being cleaned and make sure you are on
solid footing.
■ Move to the project area, raise the extension pole
and gutter cleaner attachment and hold inside the
gutter channel to be cleared. Squeeze the trigger
to begin spraying.
WARNING
Extend the wand only as much as necessary for the
project you are attempting and remain in full control of
the extension pole at all times.
■ Start cleaning at the downspout and move toward the
center of the gutter. Stay at least two feet or more from
the end cap so as not to blow gutter end cap off.
■ Move with slow, even strokes.
■ Between gutter hangers, stop spraying, lift up
on the extension pole with attachment and place
back into the gutter channel.
■ Always move from one end to another of the
gutter moving debris away from the cleaned area.
■ Lift up on the extension pole with attachment and
place back into the gutter channel.
■ Heavily soiled gutters will require multiple passes.
■ Clean up area with pressure washer and pick up
and remove any debris.
MAINTENANCE
See Figure 6.
Flathead screwdriver
Inlet plug
Filter
■ Turn off the pressure washer and shut off the
water supply. Pull trigger to release water
pressure.
■ Engage the lock-out on the trigger handle by
pushing up on the lock out until it clicks into the
fig.5
fig.6