28
MAINTENANCE
Fig. 25
Fig. 26
Fig. 27
Fig. 28
•
Disconnect chainsaw from power supply.
•
Rotate the chain cover lock knob counter-clockwise, and remove knob.
•
Remove the chain cover.
•
Remove the bar and chain from the mounting surface.
•
Remove the old chain from the bar.
•
Lay out the new saw chain in a loop, and straighten any kinks. The cutters should face in the
direction of chain rotation. If they face backwards, turn the loop over.
•
Place the chain drive links into the bar groove as shown.
NOTE: Make certain of direction of chain.
•
Position the chain so there is a loop at the back of the bar.
•
Hold the chain in position on the bar, and place the loop around the sprocket.
• Fit the bar flush against the mounting surface so that the bar studs are in the long slot of the bar.
NOTE: When placing the bar on the bar studs, ensure that the adjusting pin is in the chain tension pin hole.
•
Replace the chain cover.
•
Replace the chain cover lock knob. Rotate knob clockwise to tighten. The bar should still be
free to move for tension adjustment.
•
Remove all slack from the chain by turning the chain tensioning knob clockwise until the chain
seats snugly against the bar with the drive links in the bar groove.
•
Lift the tip of the guide bar up to check for sag.
Summary of Contents for 00-0000-0
Page 38: ...38 EXPLODED VIEW...
Page 41: ...41 NOTES...
Page 42: ...TOLL FREE HELPLINE 1 888 90WORKS 888 909 6757...
