Usage
9
Manual CAS 500
EN
Using the device
Press the power button in order to start the device. The icon is green.
When pressing the power button again, the device switches to standby mode. The icon is
now red.
When pressing this button, child lock will be activated. While active, the child lock
disables all buttons and the device keeps running as set previously.
Press the child lock button for 5 seconds to exit this mode.
When the device is running, the ionizer is automatically active. By pressing the ionizer
button on the remote control, you can switch the ionizing function off.
Press this button to set the working time. Every push increases the working time by 60
minutes. You can set between 1 - 12 hours and the device is turned off when the timer
expires.
To exit this mode, press the button until you reach 12 hours and then press once more.
When the device is running, the UV lamp is automatically active. By pressing the UV lamp
button on the remote control, you can switch the UV lamp off.
When the device is switched on, you may press the auto button in order to activate the
auto mode. In this mode, the motor speed will be adjusted automatically to the degree of
air pollution and both the ionizer as well as the UV lamp functions will be activated.
Note: If you change the wind speed during auto mode, the auto mode will be disabled.
speed level 1 & 2
: PM2.5 = 0 - 80
|
green light
speed level 3 & 4
: PM2.5 = 81 - 120
|
blue light
speed level 5 & 6
: PM2.5 = 121 - 160
|
yellow light
speed level 7 & 8
: PM2.5 = 161 - 500
|
red light
5 seconds after pressing the sleep button, the device switches to sleep mode. The lights
will be turned off and the device switches to the lowest speed level.
Press any button to wake the device up. Then press the sleep, speed
–
, speed + or auto
button in order to quit sleep mode.
Press this button to switch to the next speed level. The speed control can be set to 8
different speed levels. When pressing the button while the highest level is active, the
speed will switch to lowest level again.
Note: If you use the speed button, auto mode will be disabled.
While the device is switched on, press this button in order to see the accumulated
working time on the display. Since the screen can only display three digits, the thousands
digit will be displayed first, then hundreds, tens and single. Please read them together. If
a filter replacement was put through, this button needs to be pressed for 5 seconds in
order to reset working time. For more information, see chapter
To connect the device to your app, see chapter
POWER
CHILD LOCK
IONIZER
TIMER
UV LAMP
AUTO
SLEEP
SPEED
WiFi
RESET
