BAR
R
IER
MOWER R
I 6
0
–
80
47
6.1
INSTRUCTIONS ON SAFE SERVICE AND MAINTENANCE
(s)
TO AVOID ACCIDENTS DURING SERVICE AND MAINTENANCE, THE FOLLOWING POINTS MUST ALWAYS BE
OBSERVED:
All work on the machine must only be done when the machine is stopped, the
vehicle is switched off, the handbrake pulled, and the key removed from the
ignition lock!
When carrying out maintenance work on the attachment tool and/or multi
carrier, securing with suitable support elements must be carried out!
Only use suitable tools and use the specified personal protective equipment!
Great care should be taken when working with the machines, as there is a
danger of fingers and hands being trapped by e.g. drive belts, pulleys, knives,
guards etc.!
Immediately after finishing work, all safety and protective devices must be
installed and activated again.
During maintenance, you can often come into contact with hydraulic oil,
gearbox oil and grease. Always avoid skin contact, inhalation, etc. Always use
the correct protective equipment and use the safety data sheets for these.
ALWAYS dispose of oil and grease according to regulations!
6.1.1
MOVING YOUR GREENTEC MACHINE
GreenTec recommends storing and moving machines and tools on a suitable pallet when these are not in
use.
If these are to be moved, always use a pallet lifter or forklift.
Always check the weight of your GreenTec machine under the machine's specifications.
Materials and components used when moving the machine must be approved for more than the stated
weight of the machine
Risk of crushing, as the machine can turn and tip over during transport.
There must be no people on both sides of the machine during lifting, in the
area where the machine can tilt.
Never try to lift the multi carrier and attachment tool at the same
time/connected!
