FINAL PRE-RACE CHECKS
26
To gain the best performance out of your Goblin is it important to reduce friction:
•
Ensure the brake is not binding/rubbing. If it is then adjust the pads and/or the caliper/axle
position to ensure free running. Free running is best checked with the wheels off the ground.
•
Tyre pressures – check all tyres are inflated to the maximum pressure recommended as marked
on the tyres.
•
Wheel bearings – Ensure the bearing wheels are greased to ensure they spin freely. This doesn’t
apply to the left rear driven wheel.
•
Front wheel alignment – the front wheels should run parallel to each other. Excessive toe in or out
will reduce performance.
•
Steering – check that the steering can be turned smoothly without binding or excess slack. This is
best done with the front wheels off the ground.
•
Brake performance and adjustment – pulling on the brake lever should lock the rear axle such that
the car cannot be pulled along with driver on board without the rear wheels skidding. If this is not
the case then adjust immediately.
•
Fasteners – check all nuts and bolts are secure and tight. Loose fasteners will result in failing event
scrutineering.
•
Batteries – to maintain the best performance from your batteries they should never be left
discharged. See the page on Battery Charging for further advice.
•
Electrical Faults – Incorrect wiring installation can result in either of the two fuses blowing. If
this has happened there is a fault which needs to be corrected before proceeding. Please
be very careful as whilst the fuses are there as a safety measure incorrect wiring can in the worst
case result in fire!
