WIRING INSTALLATION
21
Note: All wires for your Goblin G2 are labelled and must be connected following the diagram on the next page.
Please take great care when installing the wiring to your car as incorrect installation may cause damage, or even
fire to wires, motor and or batteries. Always double check before connecting batteries and switching on.
Before switching on check that the rear axle rotates freely with the only resistance being from the motor. This is
best done with the rear of the car supported so the wheels are off the ground. Now switch on the isolator switch at
the rear of the car then turn on the rocker switch at the front. The red LED on the rocker switch should now be on.
If not then there is a problem which must be investigated before proceeding. If all appears well at this point press
the red button on the steering wheel. The motor should run and the rear wheels will be driven. Congratulations!
