6
3. Check that power is not present in system. Then connect the test leads to the 3-phase AC
circuit. Restore power to take reading.
4. One of the following results should appear on the display:
a. A right arrow symbol - the circuit is positive phase sequence.
b. A left arrow symbol - the circuit is negative phase sequence.
c. No arrow - the three phase circuit is only sending two phase voltage.
Temperature Measurement
1. Set the rotary selector switch to the
°
F or
°
C position.
2. Connect probe plug to Temperature Input Connector.
NOTE: Uses standard Type K thermocouple (NiCr/Ni) probes; see below for Greenlee probe
information.
3. Place probe tip in contact with item being measured. The temperature will appear on the
display.
Greenlee Temperature Probes (Type K, NiCr/Ni)
For use with 93-70 digital MultiTester and 93-1062 Digital Thermometer, plus other devices
using Type K probes.
5794-75TIP/34942 - Replacement Tip for 5794-75 Liquid Probe.
Cat./UPC No. 5791/34558
5792/34559
5793/34560
5794/34561 5794-75/34562
5795/34563
Probe Tip
Application
Pipe
Air/Gas
Semi-Solid
Liquid
Liquid
Surfaces
Range
°
F
-58 - +572
-58 - +1112
-58 - +1112
-58 - +2012
-58 - +2012
-58 - +842
(
°
C)
(-50 - +300)
(-50 - +600)
(-50 - +600)
(-50 - +1100) (-50 - +1100)
(-50 - +450)
To Measure
Heat System
Exhaust,
Meats,
Water,
Water,
Stove Plates,
Temp. of
Components
Fumes, etc.
Foods, etc.
Oil, etc.
Oil, etc.
Heat Units, etc.
Response
5 sec.
5 sec.
12 sec.
12 sec.
12 sec.
6 sec.
Length or
Max. Pipe Dia.
5"
5"
5"
29-1/2"
5"
Capacity
1-3/8" (35 mm)
(130 mm)
(130 mm)
(130 mm)
(750 mm)
(130 mm)