Greenfire Pellet Stove and Insert Technical Manual
19
PLATED DOOR INSTALLATION
TO AVOID PERSONAL INJURY DO NOT REMOVE OR REPLACE
COVER WHEN PELLET STOVE IS HOT!
TOOLS REQUIRED:
a) 11/32" socket
REMOVAL OF DOOR COVER:
When stove is off and cool, open the door. Remove the four (4) #8 hex
nuts around the inside of the glass retainer shown in Figure 37.
Remove door cover from door by gently sliding the studs out of the holes.
If it is difficult to remove the cover, the glass retainer may be pinching
the threads on the studs. Slightly loosen the four (4) screws (by each of
the studs).
REPLACEMENT OF DOOR COVER:
Slide new door cover into place and hand tighten the four (4) #8 hex nuts
around the inside of the glass retainer. Ensure the four screws are also hand
tight and close door.
Do not overtighten or you may break screws.
Clean all plated surfaces before starting the stove.
Refer to "Cleaning
Plated Surfaces in Routine Cleaning and Maintenance in the Owner's Manual.
Figure 37: Inner side of door
THERMOSTAT INSTALLATION
1.
Install the thermostat by connecting a low voltage millivolt thermostat
to the circuit board jumper location shown below. Connect 2 x 18
gauge wires from the connection points on the back of the control
board to the thermostat (see figure 38).
2.
Choose a location for the thermostat, which will effectively heat the
desired area. Do not install close to the unit, typical installation is
10ft - 20ft away in an open area (not hidden).
3.
Review each of the three control switch positions with the consum-
er.
Figure 38: Thermostat wire placement
INSTALLATION
