Greencut 1000086, Instruction Manual

Page: 67 / 88

67
EN
TROUBLESHOOTING
The table includes some of the most common problems, their causes and solutions. If the machine does not start:
THE
COMPRESSION
OF THE CYLINDER
IS NORMAL
THE SPARK
PLUG IS OK
POSSIBLE CAUSE SOLUTION
Yes Yes
• There is no fuel in the tank.
• The fuel filter is dirty.
• There is water in the fuel.
• The fuel you are using is not correct,
• The carburettor is dirty.
• Refuel.
• Clean the filter.
• Replace it.
• Change the fuel for one with the
correct octane.
• Take your machine to an authorised
service centre.
Yes No
• The switch is on the off position.
• Spark plug dirty.
• Spark plug pipe is not properly connected. • Switch to the “I” position.
• Clean the spark plug.
• Connect it.
Lack of
compression
Yes
• Loose spark plug.
• Worn pistons.
• Scratched cylinder. • Tighten.
• Take your machine to an authorised
service centre.
The engine
doesn´t turn
• Choked engine.
• Take your machine to an authorised
service centre.
If the engine does not work properly, please find below some of the possible problems, possible causes and solutions:
PROBLEM POSSIBLE CAUSE SOLUTION
The machine chimes
• Worn segments.
• Piston seizure.
• Loose crankshaft.
• Loose clutch. • Take your machine to an authorised service centre.
• Take your machine to an authorised service centre.
• Take your machine to an authorised service centre.
• Take your machine to an authorised service centre.
Engine overheating
• Operator is overworking the
unit.
• Clogged/dirty exhaust.
• Improper fuel.
• Pause every 10 minutes or allow the engine to
cool down.
• Take your machine to an authorised service centre.
• Replace fuel as appropriate.
Engine does not work
properly
• Carburador sucio.
• Filtro de aire sucio.
• Filtro de combustible sucio. • Take your machine to an authorised service centre.
• Clean the filter.
• Clean the filter.
Engine stops or does
not idle
• Carburador mal regulado. • Take your machine to an authorised service centre.
NOTE: In the event of not being able to resolve the problem, get in touch with an Official Technical
Service.