5. Assebmle the flame screen to the upper
support.
Secure the flame screen to the upper
support using 8pcs screw 3/16”.
6. Assemble the reflector onto the flame
screen. Screw the 3pcs stud on the flame
screen, put 3pcs washer Ø6 onto the top of
stud, then put the reflector onto the stud,
secure them with 3pcs washer Ø6 and
3pcs wing nut.
7. Carefully install the glass tube by lifting up
and inserting through the center hole in the
upper plate. Ensure the black silicone ring is
attached to the lower edge of the glass tube
as illustrated. Slide the glass tube through
the hole of the lower plate cover and onto
the middle plate. Check and ensure that the
glass tube is positioned properly and is
completely covering the center hole of the
middle plate.
WARNING! The black silicone ring must be
in place prior to operating the heater.
To aid in
installation
place black
silicone
ring on the middle
plate and then
install glass tube.
Ensure the rim of
the glass tube sits
firmly in the black
silicone ring.
BLACK SILICONE
RING
Philips
screwdriver
3/16” Screw
Wing nut
Washer Φ6
Stud
Hardware Used
Hardware Used