![Green Gear Cycling Bike Friday OSATA Using Manual Download Page 20](http://html1.mh-extra.com/html/green-gear-cycling/bike-friday-osata/bike-friday-osata_using-manual_2261065020.webp)
38
39
www.bikefriday.com
www.bikefriday.com
800-777-0258 • +1-541-687-0487
800-777-0258 • +1-541-687-0487
Accessories: TravelTrailer
Your Trailer Parts
If you purchased a Travel
Trailer with your bike, you
should have two trailer
wheels and two yellow felt
bags with the tongue and
axle. The bottom of your
TravelCase should have
three holes drilled in it
if you ordered the trailer
with your bike. If you
ordered the TravelTrailer
system separately, you will need to find the three dimple
marks in the bottom of your case and drill them through with
a ¼” drill. Please note the hole for the tongue (in contrast
to the two holes for the wheel axle) is offset slightly. The
reason for this is for the telescoping handle. There is a cable
running down the center inside the aluminum tunnel; offset-
ting the bolt allows the bolt for the trailer to pass through
the aluminum tunnel without striking the cable.
Fig. 60 Trailer parts.
Remove Thumb Nuts
Remove the parts out of the felt
bags and remove the thumb nuts and
one of the washers from each of the
three threaded bolts (leaving one
washer over each stud post).
Fig. 61 Trailer thumb nuts.
Install the Trailer Tongue
Turn the TravelCase upside
down (while closed). Slip
the hollow end of the
tongue over the end of the
T-piece. Take the trailer
tongue and insert its bolt
through the correspond-
ing hole on the travel case
(through the aluminum
tunnel). Note: The gentle
curve in the tongue is
located on the same side
as the side latch.
Fig. 62 Install the trailer tongue.
Accessories: TravelTrailer
Connect the Axles
Slip the open ends of the
axles over the “T” of the
T-piece. Each axle will
have a threaded bolt with
a thumb nut and a flat
washer. Pass the threaded
bolts through the holes on
the case.
Fig. 63 Connect the axles.
Add the Thumb Nuts
Carefully stand up the
case and open it. Inside
the case, place one flat
washer and one thumb
nut over each threaded
bolt and tighten them.
Fig. 64 Add thumb nuts.
THUMB NUTS
Wheel Axles
Remove the clevis pin and
bolt from the socket of
each end of the axle.
Fig. 65 Axle Bolts.