VIREO GEN3
OWNERS MANUAL - INDOOR UNIT
|
14
Press this button to turn off display light on indoor unit.
“ “ icon on remote controller disappears.
Press this button again to turn on display light. “ “ icon
is displayed.
Press this button to see the indoor set temperature on
the unit’s display. The setting on remote controller is
selected circularly as below:
Function introduction for combination
buttons
Energy-saving function
Under COOL mode, press “TEMP” and “CLOCK” buttons
simultaneously to start up or turn off energy-saving
function. When energy-saving function is started up,
“SE” will be shown on remote controller, and the unit
will adjust the set temperature automatically, to the
factory setting, to achieve maximum energy savings.
Press “TEMP” and “CLOCK” buttons simultaneously
again to exit energy-saving function.
NOTE
• Under energy-saving function, fan speed defaults to
Auto and can’t be adjusted.
• Under energy-saving function, you cannot adjust
Fan speed or use TURBO.
• If the energy-saving function has been set in the
COOL mode, pressing the “SLEEP” button will
cancel energy-saving. If the SLEEP function has
been set in the COOL mode, starting the energy-
saving function will cancel SLEEP.
Vacation mode (freeze guard) Heating in 8°C mode
or 46°F mode
In the HEAT mode, press “TEMP” and “CLOCK” buttons
simultaneously to start up or turn off this heating
function. When this function is started up, “ “ and
“46°F (8°C)” will be shown on remote controller, and
the space will not fall below 46°F (8°C). Press “TEMP”
and “CLOCK” buttons simultaneously again to exit “46°F
(8°C)” heating function.
NOTE
• Under 46°F (8°C) heating function, fan speed is
defaulted at auto speed and it can’t be adjusted.
• Under 46°F (8°C) heating function neither the
temperature nor the fan speed can be adjusted.
“TURBO” will not work either.
• Sleep function and 46°F (8°C) heating function
can’t operate at the same time. If 46°F (8°C) heating
function has been set under heat mode, pressing
the “SLEEP” button will cancel 46°F (8°C) heating
function. If sleep function has been set under heat
mode, initiating the 46°F (8°C) heating function will
cancel SLEEP function.
Remote lock-out
Press “ “ or “ “ simultaneously to turn on or turn
off Remote lock-out. When Remote lock-out is on,
“ “ icon is displayed on remote controller. If you operate
the remote controller, the “ “ icon will blink three times
without sending signal to the unit.
Temperature display switchover function
Under OFF status, press “ ” and “MODE” buttons
simultaneously to switch temperature display between
°C and °F.
Auto clean function
With the unit OFF, hold “MODE” and “FAN” buttons
simultaneously for 5s to turn the Auto Clean function
on or off. When the Auto Clean function is turned on the
indoor unit displays “CL” and the unit will cool down and
heat up rapidly. The noise you may hear is the sound
of liquid refrigerant or possibly thermal expansion and
contraction, this is normal. During the process cool or
warm air may blow, this is also normal. While in the
Auto Clean mode please make sure the room is well
ventilated to avoid any discomfort.
OPERATION OF WIRELESS REMOTE CONTROLLER (Continued)
