27
Operation procedures/pictures
8.1.5 Disassembling the cross flow fan and motor
●
Screw out the two pieces of tapping screws on the
right side of the rear case that fix the right motor
clamp and the bearing support to take out the right
motor clamp and bearing support.(As shown in
Fig.8-11)
Fig.8-11
●
Screw off the fixing screws on the right inside the
cross flow fan with screwdriver to take out the
motor enclosed by plastic. Pay attention to the angle
when the motor is installed.(As shown in Fig.8-12)
●
Screw out the tapping screws on the left side of the
rear case that fix the left motor clamp to take off the
left motor clamp and then take out the cross flow
fan.(As shown in Fig.8-13)
Tapping screws
Left motor clamp
Fig.8-13
Screws
Screws
Bearing support
Right motor clamp
Motor
Cross flow fan
Fixing screws
Fig.8-12
Summary of Contents for KFR-32GW/NJ1F
