23
Technical Information
Service Manual
icons on display modular will flicker. After the function is turned on or turned off, icon won’t flicker anymore and the startup function will be
displayed. (air and health functions are not available for low speed).
9.2. Digit in the middle:
9.2.1 When there’s malfunction protection, only error code is displayed;
9.2.2 During normal operation, if temperature or timer function is set, corresponding timer setting will be displayed for 5 seconds and then
display the set temperature (set or room temperature).
9.3. Mode:
As for auto, cooling, drying, fan and heating mode, only the selected one will be bright. Character and icon will be displayed at the same
time. Under auto mode, auto and actual operation modes will be displayed simultaneously.
9.4. Indicator control:
Operation indicator is on when turning on the unit.
9.5 Button display
Under energization and standby status, only ON/OFF indicator is bright. Press touch switch to turn on the unit directly. When touching
any other buttons, all buttons are bright. After turning on the unit, except ON/OFF button, all other buttons and display icons are controlled
by light button on remote controller. When turning off the light, touch any buttons except ON/OFF button to display all buttons. If buttons
are concealed, touch button area slightly and then all buttons will be displayed. You can perform operation during button display period. If
there’s no any button operation, button display will be concealed after 10s.
10.Button
Buttons on the control panel: ON/OFF button, cooling button, heating button, function button, scroll bar, fan speed button, left & right swing
button, up & down swing button.
10.1 ON/OFF button
Press this button to turn on or turn off the controller.
Note: under x-fan mode, press ON/OFF button can turn on the unit directly.
10.2 Cooling button
Press this button under power-on status to enter into cooling mode.
10.3 Heating button
Press this button under power-on status to enter into heating mode.
10.4 Scroll bar
10.4.1 If not setting the function, when sliding the scroll bar from left to right under power-on status, the temperature will increase; when
sliding the scroll bar from right to left, the temperature will decrease; the adjusting range is 16
℃
~30
℃
(under auto mode, the scroll bar
cannot adjust the temperature).
10.4.2 Under function setting condition, the scroll bar can be used to set timer at the range of 0-24 hours.
10.4.3 When setting other functions other than timer setting, slide the scroll bar to the right, corresponding function will be turned on; slide
the scroll bar to the left, corresponding function will be turned off.
10.5 Function button
10.5.1 Under power-on status, each time press the function button for once, the setting can switch in turns among auto, dry, swing, air,
setting, room temperature, and timer function. When certain character flickers, it means such function can be set, you can set with touching
the scroll bar, and if there is no operation after setting for 5 seconds, it means confirmation. Or press the function button again can also
confirm the setting.
10.5.2 Under power-off status and with x-fan mode status, press the function button will directly turn off the unit; Under power-off status and
without x-fan status, press function button for each time can set timer function. When certain character flickers, it means such function can
be set with touching the scroll bar, and if there is no operation after setting for 5 seconds, it means confirmation. Or press the function button
again can also confirm the setting.
10.6 Fan speed button
The fan speed button is invalid under dry and auto dry mode. When pressing fan speed button, the fan speed will display and select
according to the following ways: auto=
》
quiet (only in cooling mode)=
》
low=
》
low and medium=
》
medium=
》
medium and high=
》
high=
》
turbo.
No
Fan speed
Display
1
Quiet
2
Low
3
Low and medium
4
Medium
5
Medium and high
6
High
7
Turbo
