Multi Variable Air Conditioners Cassette Type Indoor Unit
16
4.4.2 Panel Installation
(1) Detach the panel’s Corner Cap, there is a mark “piping side” on one of the 4 corners, adjust the
panel direction so as to keep the mark and fittings on the same corner.
(2) Temporality hang the panel to body (there is four hangers on each corner of the panel, hang the
hangers to corresponding hooks on the body), as shown in Fig.4.4.4.
(3) Detach the air inlet grille from panel, make a wiring connection of signal receiver. Notices that the
connection wire not stuck in the middle of body and panel, or may cause air leakage and lead to
condensation water drop.
(4) Tighten 4 screws at each corner of panel respectively, fix the panel on the body firmly.
(5) After tightening screws, reinstall the air inlet grille.
Fig.4.4.4
4.5 Wired Controller Installation
Wired controller is optional accessory. If wired controller is needed, please contact your local dealer
and install the wired controller according to the instruction manual.
NOTE!
Do perform the commissioning operation before first use, automatic addressing or other
settings, please refer to the manual of ODU.
