![Gree GIST09BXA User Manual Download Page 41](http://html1.mh-extra.com/html/gree/gist09bxa/gist09bxa_user-manual_2260256041.webp)
Sleep3- the sleep curve setting under Sleep mode by DIY could be
inquired:
The user could accord to sleep curve setting method to inquire the
presetting sleep curve, enter into user individuation sleep setting
status, but do not change the temperature, press "Turbo" button
directly for confirmation. Note: In the above presetting or enquiry
procedure, if continuously within 10s, there is no button pressed,
the sleep curve setting within 10s, there is no button pressed, the
sleep curve setting status will be automatically quit and resume to
display the original displaying. In the presetting or enquiry procedure,
press "ON/OFF" button, "Mode" button, "Sleep"
button, the sleep
curve setting or enquiry status will quit similarly.
Press this button, could select displaying the indoor setting temperature
or indoor ambient temperature. When the indoor unit firstly power
on it will display the setting temperature, if the temperature’s
displaying status is changed from other status to " ", displays
the ambient temperature, 3s later or within 3s, it receives other
remote controller signal that will return to display the setting
temperature.
Press this button to turn on I FEEL function. " " icon is displayed
Please put the remote controller near user when this function is set.
Do not put the remote controller near the object of high temperature
or low temperature in order to avoid detecting inaccurate ambient
temperature.When I FEEL function is turned on, the remote controller
should be put within the area where indoor unit can receive the signal
sent by the remote controller.
on remote controller. The unit automatically adjust temperature
according to the sensed temperature. Press this button again to
cancel I FEEL function. " " icon will disappear.
(1)Under Sleep 3 mode, press "Turbo" button for a long time, remote
controller enters into user individuation sleep setting status, at this
time, the time of remote controller will display "1hour", the setting
temperature "88" will display the corresponding temperature of last
setting sleep curve and blink (The first entering will display according
to the initial curve setting value of original factory);
(2)Adju
st "▲
" and " " button, could change the corresponding
setting temperature, after adjusted, press "Turbo" button for
confirmation;
(3)At this time, 1hour will be automatically increased at the timer
position on the remote controller, (that are "2hours" or "3hours" or
"8hours"), the place of setting temperature "88" will display the
corresponding temperature of last setting sleep curve and blink;
(4) Repeat the above step (2)~(3) operation, until 8 hours temperature
setting finished, sleep,curve setting finished, at this time, the remote
controller will resume the original timer display; temperature display
will resume to original setting temperature.
Introduction for buttons on remote controller
SLEEP
TEMP
I FEEL
▲
37