14
❏
11. Test fi t the rudder, checking that it moves without
binding.
❏
12. Use 6-minute epoxy to glue the tail gear bearing
in
the fuselage
.
❏
13. Insert a T-pin into the center of both CA hinges.
❏
14. Insert the hinges into the trailing edge of the vertical
fi n, up to the T-pin. Note the direction of the slot.
❏
15. Apply 6-minute epoxy to the torque arm of the tail
gear and slide the rudder onto the CA hinges and torque
arm. Remove the T-pins and apply 6 drops of thin CA to
both sides of each CA hinge. Test pull the rudder to make
sure the hinges are secure.
❏
16. Install the tail wheel and wheel collar.
Install the Rudder and Elevator Servo
❏
1. Insert the rudder and elevator pushrods. Use the
pushrods to position the rudder and elevator servos.
❏
2. Mount the two servos using the screws included with
the servos. Harden the screw holes with thin CA
❏
3. Install the on/off switch and the charge receptacle.
Note:
If the plane is to be fl own as electric and the recommended
ESC is used, the on/off switch, receiver battery and charge
receptacle are not needed.
Summary of Contents for ULTRA SPORT 46
Page 31: ...Notes 31...
