Before starting to build, use the Parts Identification list to
take an inventory of this kit to make sure it is complete, and
inspect the parts to make sure they are of acceptable
quality. If any parts are missing or are not of acceptable
quality, or if you need assistance with assembly, contact
Product Support. When reporting defective or missing
parts, use the part names exactly as they are written in the
Kit Contents list on this page.
Great Planes Product Support:
Telephone: (217) 398-8970
Fax: (217) 398-7721
E-mail: [email protected]
If you are not going to install a servo inside the float, skip the
following section and go to “Assemble the Water Rudder” on
page 6.
Before starting assembly, assemble the model and mark
the balance point of the model. You will need to know this
later when the model is balanced with the floats installed.
Important Building Notes
Parts Identification
4
Hardware bag contents:
(3) SMALL NYLON TIE STRAP
(3) FLAT LANDING GEAR STRAPS, TREE OF 4
(34) #4 X 1/2" PHILLIPS HEAD SHEET METAL SCREW
(4) WHEEL COLLAR SET SCREW
(4) 5 mm WHEEL COLLAR
(35) #4 FLAT WASHER
(1) 2-56 HEX NUT
(1) 4-40 LOCK NUT
(4) #62 RUBBER BAND
(1) 2-56 X 3/8" PHILLIPS HEAD SHEET METAL SCREW
(1) 4-40 X 1/4" SOCKET HEAD CAP SCREW
(3) 2-56 X 1/2" PHILLIPS HEAD MACHINE SCREW
(1) BRASS BODY FOR SCREW-LOCK CONNECTOR
(1) NYLON RETAINER
(1) FASLINK
(1) RUBBER BOOT
(1) 4-40 x 1/8" SOCKET HEAD CAP SCREW
(1) LARGE NYLON CONTROL HORN
(1) 5/32" GEAR HUMP STRAP, TREE OF 4
(2) NYLON CLEVIS
(2) SILICONE CLEVIS RETAINER
(1) 2-56 X 1" ROD THREADED FULL LENGTH
(1) 2-56 x 6" THREADED ONE END WIRE
