19
❏
5. Insert the rudder and elevator pushrods.
❏
6. Install the rudder and elevator servos. After installing
the servo screws, remove them and apply a drop of thin CA
in each hole. After the CA cures, reinstall the screws.
❏
7. Connect the servos to the receiver and center the servos.
Basic and Advanced Set-up:
Plug the servos directly into
the receiver.
S.Bus with non S.Bus servos:
Set the channels to 2 and 4 on
a 400mm Decoder. Connect the elevator to channel 2 and the
rudder to channel 4. Plug the Decoder into the Terminal box.
S.Bus with S.Bus servos:
Program the servos and
plug both
servos into the Terminal box.
❏
8. Install the rudder and elevator control horns and clevises
following the same procedure used to install the aileron
pushrods.
