27
❏
2. Adjust the location of the pushrod on the servo arm or
on the control horn fi rst. Then, use the endpoint adjustment
in your transmitter to fi ne tune the throws.
❏
3. Measure and set the
low rate
throws. Measure and
set the high and low rate throws for the rest of the control
surfaces the same way.
These are the recommended control surface throws:
These are the recommended control surface throws:
ELEVATOR
HIGH
LOW
7/8"
[ 22 mm]
14°
1/2"
[ 12 mm ]
8°
1-1/2"
[ 38 mm ]
29°
1-1/8"
[ 28 mm]
21°
1-1/4"
[ 32 mm]
17°
4"
[ 102 mm ]
41°
2-1/2"
[ 63 mm]
24°
RUDDER
AILERONS
FLAPS
Up & Down
Up & Down
Right & Left
We also mixed in 3/32"
[2.5mm] down elevator with
flaps to reduce balooning.
❏
4. Once the throws are set, apply a drop of threadlocker
to the threads and tighten the 4-40 nuts against the clevises.
Slide the silicone retainers over the clevises.
IMPORTANT! IMPORTANT! IMPORTANT!
Now that you have the throws set, be sure to set the fail-safe
on the radio.
Install the Propeller
❏
1. Balance the propeller.
❏
2. Install the propeller. Drill holes through the propeller
as necessary.
❏
3. Install and secure the hatch cover with the 1/4-20 x 1"
thumb screw.
