❏ ❏
4. Securely attach the string to the end of the servo
lead. The other end of the string is attached with tape on the
inside of the wing near the root. Pull this end of the string up
and through the small 1/2" [13mm] hole in the top of the
wing panel. You will need to remove the covering from this
small hole using a sharp hobby knife.
❏ ❏
5. Pull the string to route the servo lead through the
wing and out the small hole in the top of the wing.
❏ ❏
6. Attach the servo lead to the wing panel with a small
piece of masking tape.
❏ ❏
7. Mount the servo to the wing using the hardware
provided by your manufacturer. The output shaft spline will
face the LE of the wing. Remove the servo mounting screws
after installing the servo and harden the screw holes by
wicking some thin CA into them and allowing it to harden.
Then reinstall the servo mounting screws.
❏
8. Repeat steps 1 to 7 for the other wing panel.
❏
9. If using a four servo setup, you will repeat steps 1 to
7 above for the top wing. The 1/2" [13mm] holes for the
servo leads to exit the bottom of the top wing are located
further in from the center of the wing than as on the bottom
wing. Remove the covering from these holes only if using
the aileron servos in the top wing.
❏
1. Locate the large wing joiners for the bottom wing.
These will be the large rectangular joiner and the larger of
the two small angled joiners. Measure and mark the centers
of the joiners.
❏
2. Test fit the wing joiners into one wing panel. Sand the
wing joiners as needed for a good fit.
❏
3. Slide the other wing panel onto the wing joiners. Sand
the wing joiners as needed for a good fit. The wing roots
should be flush with little or no gap present.
❏
4. Separate the wing panels and remove the wing joiners.
❏
5. Mix a large batch of 30-minute epoxy (if using mixing
cups, 1 oz. [28g] of mixed epoxy is a good amount.)
❏
6.
Thoroughly coat the inside of the wing joiner pockets
and wing roots with 30-minute epoxy.
❏
7. Apply epoxy to each of the wing joiners and insert
them into the pockets in one wing panel.
Join the Bottom Wing
10
